Filter
Top Products
User Manual MON20/20 Software for Gas Chromatographs
3-9000-745 SEPTEMBER 2010
3-6
3.1.5 Setting the desired temperature
To set the desired temperature for a heater, do the following:
1. Select Heaters... from the Hardware menu. The Heaters window
displays.
Figure 3-5. The Heaters window
2. For each heater that you want to set, select Auto from the appropriate
row under the Switch column.
3. For each heater that you want to set, double-click on the appropriate
row under the Setpoint column, and enter the desired temperature, in
degrees Celsius. You can enter a value between 20 and 500.
4. To exclude a heater from the Warm Start process, select its Ignore
Warm Start check box.
Note
A warm start occurs when the GC restarts after having been shut down during an auto
sequence analysis run. The GC will activate the heaters and wait until they reach their
setpoints and the temperature stabilizes; the GC will then resume the auto sequence
run.