Filter
Top Products
MON20/20 Software for Gas Chromatographs User Manual
SEPTEMBER 2010 3-9000-745
7-13
11.To edit the template, select a data type for each desired offset.
12.To change all offsets to the same data type, change the first offset to
the desired data type, and then click Auto Reset. The data type for
the remainder of the offsets switch to the data type of the first offset.
13.To save the displayed file to disk, click Save As.... The Select
Template Configuration File dialog appears. Type in a filename and
click Save.
14.Click OK to apply your selections and return to the main window.
7.1.6 Setting the log parameters
The Log Data window allows you to log the polled data to a specified file.
Note
The Log Data function is not necessary to transmit Modbus data. To disable this
function, clear the Enable Logging ‘Data’ Registers and Values check box on the Log
Data window.
To set the log parameters for the Modbus program, do the following:
1. Click Log Data. The Log Data window displays.