Filter
Top Products
MON20/20 Software for Gas Chromatographs User Manual
SEPTEMBER 2010 3-9000-745
3-45
2. Select the desired mode from the drop-down menu under the Switch
cloumn for the analog output.
3. To save the changes and leave the window open so that you can
monitor the analog output, click Save. To save the changes and close
the window, click OK. The current value of the analog output displays
in the Cur Val column, and is updated in real time.
3.7.3 Setting the scale values for an analog output device
To set the zero scale and full scale, which are used when converting the
analog output value, do the following:
1. Select Analog Output... from the Hardware menu. The Analog
Output window displays.
Figure 3-36. The Analog Outputs window
2. Click on appropriate row under the Zero Scale column and enter a
zero scale value.
3. Click on appropriate row under the Full Scale column and enter a full
scale value.
4. To save the changes and leave the window open so that you can
monitor the analog input’s progress, click Save. To save the changes
and close the window, click OK.