Filter
Top Products
User Manual MON20/20 Software for Gas Chromatographs
3-9000-745 SEPTEMBER 2010
4-22
The following table describes the valve-related parameters that are
available on the timed events window.
4.3.2 Editing integration events
Integration-related events are grouped on the upper right side of the
Timed Events window. To edit integration-related events, do the
following:
1. Select Timed Events... from the Application menu. The Timed
Events Tables selector window appears, displaying a list of available
timed events tables.
Parameter Description
TEV Type The type of event. You have the following choices:
• Valve # - A valve.
• DO # - A discrete output.
• Strm Sw - Switches to the next stream in the sequence.
• FID Gain - Sets the FID to high or low gain.
• FID Auto Zero - Zeros the FID preamp after a gain change.
Valve/DO # Use the drop-down menu to select the specific valve or discrete output that should be
used for the event.
This column does not apply if Strm Sw, FID Gain or FID Auto Zero was selected from
the TEV Type column.
State Turns the valve or discrete output on or off, or sets the FID to high or low.
This column does not apply if Strm Sw or FID Auto Zero was selected from the TEV
Type column.
Time Indicates the time, in seconds, that the event should occur during the analysis. Enter a
value between 0.0 and 3600.0.
NOTE: Event times must be less than the analysis time.