Filter
Top Products
MON20/20 Software for Gas Chromatographs User Manual
SEPTEMBER 2010 3-9000-745
5-45
2. The following types of potential reports are listed in the Report Name
column:
• Analysis (GPA) - An analysis report will print after an analysis
run is completed.
Note
If ISO is set in the Calculations Configuration screen, Analysis (ISO) will be listed
under the Report Name column instead of Analysis (GPA); if GPA & ISO is set in the
Calculations Configuration screen, the both Analysis (ISO) and Analysis (GPA) will be
listed under the Report Name column.
• Calibration - An calibration report will print after an calibration
run is completed.
• Final Calibration - An final calibration report will print after a
final calibration run is completed.
• Validation - An validation report will print after an validation
run is completed.
• Final Validation - An final validation report will print after a
final validation run is completed.
• Every Run - A report will be generated each time an Every Run
average calculation is run.
• Hourly: A report will be generated each time an Hourly average
calculation is run.
• 24 Hour: A report will be generated each time a 24 Hour average
calculation is run.
• Weekly: A report will be generated each time a Weekly average
calculation is run.
• Monthly: A report will be generated each time a Monthly average
calculation is run.
• Variable: A report will be generated each time a Variable average
calculation is run.
• Raw Data - Each time raw data is generated, a report will be
printed.
3. To print a report after a run, check the appropriate checkbox from the
Print After Completion? column.