Filter
Top Products
Enhanced Serial Audio Interface
DSP56364 24-Bit Digital Signal Processor Users Manual, Rev. 2
Freescale Semiconductor 2-11
FST Input or output GPIO
disconnected
Frame Sync for Transmitter—This is the transmitter frame sync
input/output signal. For synchronous mode, this signal is the frame sync for
both transmitters and receivers. For asynchronous mode, FST is the frame
sync for the transmitters only. The direction is determined by the transmitter
frame sync direction (TFSD) bit in the ESAI transmit clock control register
(TCCR).
PC4 Input, output, or
disconnected
Port C 4—When the ESAI is configured as GPIO, this signal is individually
programmable as input, output, or internally disconnected.
The default state after reset is GPIO disconnected.
This input is 5 V tolerant.
SCKR Input or output GPIO
disconnected
Receiver Serial Clock—SCKR provides the receiver serial bit clock for the
ESAI. The SCKR operates as a clock input or output used by all the enabled
receivers in the asynchronous mode (SYN=0), or as serial flag 0 pin in the
synchronous mode (SYN=1).
When this pin is configured as serial flag pin, its direction is determined by
the RCKD bit in the RCCR register. When configured as the output flag OF0,
this pin will reflect the value of the OF0 bit in the SAICR register, and the
data in the OF0 bit will show up at the pin synchronized to the frame sync in
normal mode or the slot in network mode. When configured as the input flag
IF0, the data value at the pin will be stored in the IF0 bit in the SAISR
register, synchronized by the frame sync in normal mode or the slot in
network mode.
PC0 Input, output, or
disconnected
Port C 0—When the ESAI is configured as GPIO, this signal is individually
programmable as input, output, or internally disconnected.
The default state after reset is GPIO disconnected.
This input is 5 V tolerant.
SCKT Input or output GPIO
disconnected
Transmitter Serial Clock—This signal provides the serial bit rate clock for
the ESAI. SCKT is a clock input or output used by all enabled transmitters
and receivers in synchronous mode, or by all enabled transmitters in
asynchronous mode.
PC3 Input, output, or
disconnected
Port C 3—When the ESAI is configured as GPIO, this signal is individually
programmable as input, output, or internally disconnected.
The default state after reset is GPIO disconnected.
This input is 5 V tolerant.
Table 2-10 Enhanced Serial Audio Interface Signals (continued)
Signal
Name
Signal Type
State during
Reset
Signal Description