Filter
Top Products
5 - 12 5 - 12
5.2 Transferring data with RS-232C cable
The data transfer method with RS-232C cable is described.
As data transfer is operated with the GT Designer2, operation on the GOT side is not necessary.
Procedures
The data is transferred in the following procedures.
Memory board
When the user area is not sufficient
or the extended function is used
Transfer data
Dedicated
memory
Built-in memory
Set communication
on the GT Designer2.
ROM_BIOS
Extended function OS
Communication driver
Extended function OS
Monitor data
Special data
Connect a RS-232C cable.
Transfer
Get the built-in memory information.
Upload
Set communication on the GT Designer2.......... Item 5.2.1 Setting communication
Connect a RS-232C cable. ................................ Item 2.2.2 RS-232C cable to be used
Get the built-in memory information................... Item 5.2.2 Getting built-in memory information
Upload (Operation is not required for the first upload.)
..........................................................................
Item 5.2.3 Uploading
ROM_BIOS (GOT-A900 Series only) ................ Item 5.2.4 Installing ROM_BIOS
Standard monitor OS, communication driver and extended function OS (GOT-A900 Series only)
..........................................................................
Item 5.2.5 Installing OS
Monitor data....................................................... Item 5.2.6 Downloading monitor data
Special data (GOT-A900 Series only)................ Item 5.2.7 Downloading special data
Remark
Monitor data transfer
To transfer monitor data, the project must be opened on the GT Designer2.
Other data than the monitor data can be transferred when the project is not opened
on the GT Designer2.