Filter
Top Products
5 - 26 5 - 26
5.3 Transferring Data Using PC Card
Data transfer method with the PC card is described.
With a PC card, it is not necessary to carry a PC or cable.
The data transfer time is faster than that of the communication with the RS-232C cable.
1
The working time can be reduced.
Procedures
Data is transferred with the procedures below.
Memory board
When the user area is not sufficient
or the extended function is used
Transfer data
Dedicated
memory
Built-in memory
ROM_BIOS
Standard monitor OS
Communication driver
Extended function OS
Monitor data
Special data
Transfer
1 Reference value....For screen data (589,572 bytes (30 screens)), approx. 55 sec. for PC card and approx. 5 min. for RS-232 cable
2 When the GOT-F900 Series is used, data cannot be transferred with the PC card.
3 Data in and can be transferred at the same time depending on the PC card size.
ROM_BIOS ......................... Section 5.3.1 Installing ROM_BIOS
Standard monitor OS, communication driver and extended function OS
...............................................
Section 5.3.2 Transferring OS, monitor data and special data
Monitor data and special data
...............................................
Section 5.3.2 Transferring OS, monitor data and special data
Remark
Monitor data transfer to PC card
To transfer monitor data from the PC to the PC card, the project must be
opened on the GT Designer2.
Other data than the monitor data can be transferred even if the project is not
opened on the GT Designer2.