Filter
Top Products
3 - 25 3 - 25
Point
(1) Operation in automatic save setting
If the GT Designer2 stops or a power failure occurs in automatic save setting,
the GT Desinger2 shows the dialog box below at the next start-up.
• If a project file is available (a project is saved in the past), this dialog box
appears when the project file is opened.
• If a project file is not available (no saving after new creation), this dialog
box appears when the GT Designer2 is started.
When Yes is selected on the dialog box above, the automatically saved file is
recovered.
When either Yes or No is selected, the automatically saved recovery file is
erased.
It is recommended to select Yes and to check that the saved recovery file is
necessary.
(2) Precautions for multiple start of GT Designer2 with automatic save setting
When automatic save is set, do not perform the following operations.
The message in (1) above appears at the start-up of the 2nd or subsequent GT
Desinger2 and the automatically saved file is then erased.
Reset the automatic save for the following operations:
(a) After new creation, start the 2nd or subsequent GT Designer2 while editing
a project which has not been saved at all.
(b) Open the project which has been opened on the GT Designer2 with the 2nd
or subsequent GT Designer2.