Filter
Top Products
5 - 27 5 - 27
Precautions
(1) Module mounted on the GOT
When data are transferred, remove the communication module/board and extended module
mounted on the GOT.
When the GOT has the built-in communication interface, remove the communication cable.
(2) Detailed explanation and category set on project or screen
Detailed explanation and category set on the project or screen are not downloaded to the GOT.
After downloading, they are not saved when they are uploaded again from the GOT.
(3) Transfer method of monitor data to PC card
Be sure to transfer the monitor data from the GT Designer2 to the PC card.
If data is copied with Explorer of the PC, the GOT cannot check the data in the PC card.
(4) Data in GOT/PC card
When the same data as the data to be downloaded is already present in the GOT/PC card, it is
overwritten in downloading.
(5) PC card format
Format the PC card before use.
The following format methods are available:
(a) Format with PC (SRAM type, flash PC card)
Format the PC card on the PC satisfying the conditions below:
1) The PCMCIA card slot is available.
2) Windows 98, Windows Me or Windows 2000 is installed.
(The PC card cannot be formatted with Windows NT 4.0.)
Point
Formatting with PC
Format the PC card (SRAM type PC card, flash card) for the GOT using FAT16
type:
To make the SRAM type PC card recognized on Windows
R
98, statement must be
added to config.sys.
Refer to Help of Windows
R
98 for details.
(b) Format with self-diagnosis (memory card check) of utility menu
Only the SRAM type PC card can be used.
Refer to the GOT-A900 Series operating manual (Extended functions and Optional
functions corresponding to GT Works2 Version1/GT Designer2 Version1) for details of
the utility menu.
(6) Transfer (write) time to memory card
The transfer time from GT Designer2 to memory is affected by the PC environment. Therefore,
it may take longer until the data transfer will be completed, depending on the memory card and
the OS (Windows) in the PC.