Filter
Top Products
FX
3G
/FX
3U
/FX
3UC
PLC User's Manual - Positioning Control Edition
Built-in Positioning Functions
11 Batch Data Positioning Mode (TBL Instruction)
11.4 Positioning Parameter Setting
B - 145
A
Common Items
B
Built-in
Positioning
Functions
Apx.
Example
Connection
11.4 Positioning Parameter Setting
Use GX Developer Ver.8.23Z or later to set the positioning parameters in the FX3U/FX3UC PLC. Use GX
Developer Ver.8.72A or later to set the positioning parameters in the FX
3G PLC.
The "number of pulses" and "frequency" set by the positioning parameters in a positioning table can be
changed using the program, display module, or HMI.
→ To change the set "number of pulses" or "frequency", refer to Subsection 11.4.2.
11.4.1 Positioning Parameter Setting Using GX Developer
Assuming that GX Developer Ver.8.23Z or later is used, this section describes how to set the positioning
parameters.
1 Open the "parameter setting" window.
On the project tree displayed on the left side of the screen, double-click "Parameter" and then "PLC
Parameter".
If the project tree is not displayed, click "View" on the menu bar, and then click "Project data list"