Filter
Top Products
FX
3G
/FX
3U
/FX
3UC
PLC User's Manual - Positioning Control Edition
Built-in Positioning Functions
12 Examples of Programs
12.4 Positioning Using Batch Setting Method
B - 164
3 Click on the "Positioning" tab, and then set Y000 (pulse output destination)
as follows.
Before clicking on the "Positioning" tab, click on the "Memory Capacity" tab, and then enter a check in the
"Positioning" check box. After entering a check, positioning data can be set.
After entering a check, positioning data can be set. Use the FX
3U/FX3UC PLC of Ver.2.20 or later or FX3G PLC
to use "Positioning".
*1. Only available for FX
3U and FX3UC PLCs.
4 Click on the "Individual setting" button. The "Individual setting" setting
window will appear. In this window, click on the "Y000" tab to display the
positioning table for Y000 (pulse output destination). Set the data in the
positioning table as follows:
Setting item Setting value
Bias speed (Hz) 500
Maximum speed (Hz) 100,000
Creep speed (Hz) 1000
Zero return speed (Hz) 50,000
Acceleration time (ms) 100
Deceleration time (ms) 100
Interrupt input for DVIT instruction
*1
X000
Setting item Setting value
Rotation direction signal Y004
First device R0
No. 1
Positioning type DDRVI
(drive to increment)
Number of pulses (PLS) 999,999
Frequency (Hz) 30,000
No. 2
Positioning type
DDRVI
(drive to increment)
Number of pulses (PL
S)
-999,999
Frequency (Hz) 30,000
No. 3
Positioning type
DDRVA
(drive to absolute)
Number of pulses (PLS) 500,000
Frequency (Hz) 100,000
No. 4
Positioning type
DDRVA
(drive to absolute)
Number of pulses (PLS) 100
Frequency (Hz) 100,000