Filter
Top Products
3 Connection of Input/Output Lines and Tightening
3.2 European Terminal Board
B - 34
FX
3G
/FX
3U
/FX
3UC
PLC User's Manual - Positioning Control Edition
Built-in Positioning Functions
• When two wires are connected to one terminal
3.2 European Terminal Board
The European terminal board is used for the high-speed output special adapter and the FX2NC Series input/
output extension block.
3.2.1 Cable
Applicable cables and tightening torques
3.2.2 Termination of Cable End
Directly terminate the end of each stranded cable or single-wire cable without a tool, or use the rod terminal
with insulation sleeve for termination.
• Directly terminate the end of the stranded/single-wire cable:
- Terminate the end of the stranded cable so that "barbed wires"
cannot protrude.
- Do not solder-plate the end of the cable.
• Terminate the cable end using a rod terminal with insulation sleeve:
If the cable sheath is too thick, it may be difficult to insert the cable
into the insulation sleeve. For this reason, select an appropriate cable
while referring to the external view.
Wire size (stranded/
single wire)
Tightening
torque
Termination
Single-wire
0.3 mm
2
to 0.5 mm
2
(AWG22 to 20)
0.22 to
0.25 N
•m
• To connect a stranded cable, peel the sheath off the cable,
and then twist the core before connection.
• To connect a single-wire cable, just peel the sheath off the
cable before connection.
2-wires
0.3 mm
2
(AWG22)
Rod
terminal
with
insulation
sleeve
0.3 mm
2
to 0.5 mm
2
(AWG22-20)
(Refer to the external
view of the rod terminal
shown in the following
figure.)
• Rod terminal with insulation sleeve
(recommended terminal)
AI 0.5-8WH: Manufactured by Phoenix Contact
• Caulking tool:
CRIMPFOX ZA 3: Manufactured by Phoenix Contact
(or CRIMPFOX UD 6: Manufactured by Phoenix Contact)
Manufacturer Model Caulking tool
Phoenix Contact AI 0.5-8WH
CRIMPFOX ZA 3
(or CRIMPFOX UD 6)
6.8mm(0.27")
or less
3.7(0.15")
6.0mm(0.24")
or more
Terminal
screw
Crimp
terminal
Terminal
6.8mm(0.27")
or less
3.7(0.15")
6.0mm(0.24")
or more
9mm
(0.36")
•
Stranded wire/solid wire
8mm
(0.32")
Contact portion
(Crimp area)
14mm(0.56")
2.6mm
(0.11")
Insulating sleeve
•
Bar terminal with insulating sleeve