A SERVICE OF

logo

Switcher Software, cont’d
ISS 506 Integration Seamless Switcher • Switcher Software
5-10
4. Click in the Enter logo name field, type in a name for you logo, and click
the Start Capture button. The program displays a window that shows the
progress of the capture (figure 5-9). Depending on the size of the logo, this
can take a few minutes.
Figure 5-9 — Capturing Logo window
N
The program does not allow you to enter a dot (period) and automatically
assigns the *.bmp extension.
5
. If necessary, click (deselect) the Yellow Border checkbox to turn off the crop
marks:
Recalling and configuring a logo
Recall and configure a logo as follows:
1
. Click the appropriate Logo radio button in the Logo Setup area to select a logo
to which to assign the image.
2
. Click on the desired image’s file name in the Select Logo field. Click the Select
Logo button to load the image to the Logo button. The program displays a
window that shows the progress of the selection (figure 5-10). Depending on
the size of the logo, this can take a few minutes.
Figure 5-10 — Selecting Logo window
When the selection is complete:
• TheimageassignedtothelogobuttonisshowninblueintheSelectLogo
field.
• Thelogoisdisplayedontheselectedoutput.
• TheLogoSetupScreenshowsthelogo’srelativesizeandlocation(thelogo
is in green).
3
. Click and drag the center of the logo in the Logo Setup Screen to center the
position the logo as desired.
4
. Click the desired method (Color or Luma) for keying out the unwanted
material from the logo in the Key Type field.
5
. Watch the logo on the connected output device while you click the up
arrows ( ) and down arrows ( ) in the Key Type field to key out unwanted
material, such as the background, from the logo.