A SERVICE OF

logo

3-39
ISS 506 Integration Seamless Switcher • Operation
Rear Panel Reset Button
The switcher’s Reset button is on the rear panel (figure 3-32).
RS232/422
RESET
B/
B-Y
PREVIEW
RGB/R-Y, Y, B-Y
RGB/R-Y, Y, B-Y
R
PREVIEW
LAN
12
Figure 3-32 — ISS 506 rear panel Reset button
l
Reset button and LED — Use the Reset button and LED to perform four
levels of system resets. See below.
Performing soft system resets
The ISS 506 has three soft resets available that restore various tiers of switcher
settings to their default settings.
• Events (mode 3) reset — This function toggles the monitoring of events on
or off (if events monitoring was on, this function turns it off; if it was off, it is
turned on).
• IP settings (mode 4) reset — The IP settings reset performs the following
functions:
Enables Arp program capability.
Resets the IP address to the factory default (192.168.254.254).
Resets the subnet mask to the factory default (255.255.0.0).
Resets the gateway address to its factory default (0.0.0.0).
Resets port mapping to the factory default.
Turn DHCP off.
Turn events off.
N
IP settings reset does not replace any user-installed firmware.
• Absolute (mode 5) reset — Absolute reset restores the switcher to the
default factory conditions. This function is identical to the
Esc
ZQQQ SIS
command, see chapter 4, “SIS
Programming and Control”.