A SERVICE OF

logo

6-15
ISS 506 Integration Seamless Switcher • HTML Operation
Input presets
N
User presets consist of:
• Filmmode • Totalpixels
Programphase • Previewphase
Horizontalstart • Verticalstart
Horizontalactivepixels • Verticalactivepixels
Horizontalsize • Verticalsize
Brightnesssandcontrast • Detail
• Horizontalposition • Verticalposition
• Color • Tint
There are 128 presets associated with each input. These presets, ideal for use
when the associated input is an Extron matrix switcher, contain the entire range
of adjustments, listed above, available for that input. If the input is from a matrix
switcher
, you can tailor a preset for each possible video signal that the matrix
switcher can tie to the ISS. Save or recall an input preset as follows:
1
. Click the Output dropbox.
2. Select the Program or Preview output.
3. Click the Preset number dropbox.
4. Select the desired preset number.
5. Click either the Save or Recall button.
PIP settings page
You can set variables associated with the picture-in-picture function from the PIP
Setup page (figure 6-14). Access the PIP setup page by clicking the PIP Setup
link on the User Control page. See chapter 3, “Operation” for descriptions of the
settings on this page.
Presets
User Control
Refresh
Logos
Figure 6-14 — PIP Settings page
Select the PIP Window or PIP Image radio button to assign the setting that you
make to the window or to the image.