A SERVICE OF

logo

HTML Operation, cont’d
ISS 506 Integration Seamless Switcher • HTML Operation
6-10
To set up e-mail addresses for notification, do the following for each recipient of
e-mail alerts:
1
. Click the Edit button at the end of the address row. The Edit button changes
to Save.
2
. Enter the e-mail address of the recipient, and the file name on your PC
(*.eml extension) that contains the message.
3
. Click the Save button to save the changes. The Save button changes back to
Edit.
Setting up SMTP authorization
Set the ISS to require SMTP authorization before accepting any e-mail as follows:
1
. To enable the SMTP authorization fields, click the Edit button at the right of
the Mail IP Address field. The Edit button changes to Save.
2
. Select the SMTP Authorization Required check box, located below the Domain
Name field. This enables the User Name and Password fields below the check
box.
3
. In the User Name and Password fields, enter a user name and a password that
senders must enter in order for the ISS to accept their e-mail messages.
N
For the User name, you can use any combination of letters, numerals, spaces,
and symbols except the comma (,) and the single and double quotation marks
( and ). For the password, you can use all characters except the comma. The
user name and password can each be from 1 to 30 characters.
N
You must specify both a user name and a password.
4
. Click the Save button next to the Mail IP Address field to save your user name
and password.
To remove SMTP authorization, click Edit, click (deselect) the SMTP Authorization
Required check box, then click Save.
Firmware Upgrade page
The Firmware Upgrade page provides a way to replace the firmware that is coded
on the switcher’s control board without taking the switcher out of service, opening
the switcher enclosure, and replacing the firmware chip. Access the Firmware
Upgrade page (figure 6-9) by clicking the Firmware Upgrade link on the System
Configuration page.
Scan Converter Board*
ISS Settings
System Settings
Passwords
Email Alerts
Refresh
* The Scan Converter Board link is available only if the optional scan converter output board is
installed.
Figure 6-9 Firmware Upgrade page