Filter
Top Products
System Configuration Manual
300510EN, Rev AA
December 2010
Rosemount Raptor
5-74
Section 5. Installing a Raptor Level Gauging System
5.8.6 Advanced Parameter Source Configuration
The Advanced Parameter Source Configuration tab lets you map the output of
various measurement instruments (source devices) to tank measurement
variables such as Liquid Pressure and Vapor Pressure. That makes the
measurement variables available for configuration in the Tank Configuration
window as described in “Installing a New Tank” on page 5-103.
Tank measurement variables such as Level, Vapor Temperature, and Free
Water Level are automatically mapped to source devices and do not need to
be mapped in the Advanced Parameter Source Configuration tab.
The Rosemount 2410 Tank Hub supports 60 source parameter mappings. Six
mappings are reserved for each one of the ten 2410 tank positions.
NOTE
A warning message will appear in case a certain parameter/source mapping
is already used for another tank.
For a source device to be available in the Advanced Parameter Source
Configuration tab, it must be mapped to the current tank in the 2410 tank
database (see “Installing a Rosemount 2410 Tank Hub” on page 5-38 for
more information).
To map parameters to source devices, perform the following steps:
1. In the 22xx ATD window, select the Advanced Parameter Source
Configuration tab:
2. In the Parameter Mapping column choose a tank measurement variable.