Filter
Top Products
System Configuration Manual
300510EN, Rev AA
December 2010
7-13
Rosemount Raptor
Section 7. Service Functions
4. The order in which registers are displayed in the View Diagnostic
Registers window can be configured. Select a register in the right pane
and press to move it upwards, or to move it downwards
in the list.
5. The Log Setup button provides easy access to the Register Log
Scheduling window, which allows you to setup a log schedule for
automatic start and stop of register logging. See “Logging Measurement
Data” on page 7-14 for more information.
6. Press OK to store the current configuration.
7.6.2 Restore to
Default Setting
In case you wish to restore the View Diagnostic Registers window to the
default setup, you need to remove the file that contains the current
configuration data for the View Diagnostic Registers window.
To restore to the default setting do the following:
1. In Windows Explorer open the following folder:
C:\Rosemount\TankMaster\Setup\Data,
where C:\ is the drive letter associated with the hard disk on which
TankMaster is installed.
2. Locate the configuration file for the device whose diagnostic register
setup you wish to restore:
3. Remove the *.ini file, or rename it in case you wish to store the file for
future use (for example R2410.old).
4. Start TankMaster WinSetup and open the View Diagnostic Registers
window to verify that the View Diagnostic Registers window shows the
default setting of diagnostic registers.
Device Configuration file
2410 Tank Hub R2410_diag.ini
5900S Radar Level Gauge R5900_diag.ini
2240 Multi-Input Temperature
Transmitter and Auxiliary Tank
Devices (ATD)
R22XX_diag.ini