Filter
Top Products
System Configuration Manual
300510EN, Rev AA
December 2010
5-105
Rosemount Raptor
Section 5. Installing a Raptor Level Gauging System
Show 2160 FCU Slave Positions (Advanced)
The “Show Slave Positions” check box should only be used for advanced tank
configuration of devices which are not supported by the Raptor system.
A Rosemount Raptor device which is connected to the Tankbus and
configured in the 2160 FCU Slave Database, will appear in the Available
Devices pane at the left-hand side of the Select Devices window.
In case a device which can not be identified by the Raptor system is
connected to the Tankbus, you will have to select the “Show Slave Positions”
check box in order to map this device to a tank.
To associate an “unknown” device to a tank do the following:
a. In the Select Devices window, check the Show FCU Slave Positions
check box to display the positions of the 2160 FCU Slave Database.
b. In the Select Devices window choose the Slave Database position
that corresponds to the tank where the device is installed.
In the example above the devices are mapped to position 3 which is
identified as FCU-201.03 in the FCU Slave Database.
c. Move the selected item to the Selected Devices pane by clicking
the button.
7. Click the Next button to proceed with the tank installation.