Filter
Top Products
System Configuration Manual
300510EN, Rev AA
December 2010
Rosemount Raptor
8-4
Section 8. Menu Guide
When selecting a tank in the Tanks folder, new options are available under the
Service > Tanks menu:
When selecting a device in the device folder, new options are available under
the Service > Devices menu:
Tanks > Unistall Remove the selected tank.
Rename Change the tank name.
Open Tank
View
View various tank related variables such as level,
level rate, average temperature etc. for a single
tank.
Calibrate Use the built-in calibration function to adjust the
still-pipe correction factor and Calibration Distance.
Tank Entry Configure product data for inventory calculations.
Hybrid Tank
Setup
Define pressure sensor positions for hybrid tank
gauging.
Tank capacity Specify a Tank Capacity Table (strapping table).
Tank Volume
Calculation
Define settings for the tank volume calculation.
Properties View and change tank configuration parameters.
2160 Field Communication Unit
Devices > Expand all Show all devices connected to the Rosemount 2160
Field Communication Unit.
Collapse All Close the device folder.
Uninstall Remove the selected device.
Save
database to
file
Save the current holding register setup to file. This
function can be useful if you would like to save a
backup of the current database. It can be
downloaded to a device by choosing the Upload
Database option.
Upload
Database
Upload a database to the selected device.
View Input
Registers
View input register values. You can choose
between a predefined set of registers or you can
specify a certain range of registers.
View Holding
Registers
View holding (database) register values. You can
choose between a predefined set of registers or you
can specify a certain range of registers.
View
Diagnostic
Registers
View the diagnostic registers for the selected
device.
Restart Restart the selected device. The boot software
performs an initialization procedure and memory
tests.
Logging Log the diagnostic registers.
Properties View and change the current device settings (not in
View Only mode).