Filter
Top Products
System Configuration Manual
300510EN, Rev AA
December 2010
Rosemount Raptor
5-16
Section 5. Installing a Raptor Level Gauging System
5.3 PREFERENCES
5.3.1 Measurement
Units
Specify units for inventory calculations and measured variables such as level
and temperature. To change measurement units do the following:
1. Select the desired server (e.g. “This Workstation”) in the WinSetup
workspace.
2. Click the right mouse button and choose Setup, or from the Service
menu choose Servers>Setup.
3. In the Server Preferences window select the Units tab.
4. Choose the desired measurement units for level/ullage, temperature,
pressure, volume, density, and weight.
5. Click the OK button to save the current setting and close the window.
NOTE!
Make sure that the desired measuring units are specified before installing new
tanks and devices.
Note that these settings only affect installation of new tanks. Tanks which are
already installed in the WinSetup Workspace will not be affected. In order to
change measurement units for an existing tank you have to do the following:
1. Uninstall the tank.
2. Change measurement units in the Server Preferences/Units window (or
in the TankMaster WinOpi program choose menu option Setup>System
and change units in the System Setup window).
3. Install the tank again.