Sony CCp-8000 Water Dispenser User Manual


 
Chapter 13 Keyframe Effects
116
Recalling a Register
2
Press the button corresponding to the region you want to select, turning it
on.
You can also press more than one button.
[M/E 1], [M/E 2], [M/E 3], [P/P]: These select the corresponding M/E-1,
M/E-2, M/E-3, and PGM/PST regions.
[USER 1] to [USER 8]: These select the USER regions.
[DME 1] to [DME 4]: These select DME channels.
[DEV 1] to [DEV 12]: These select the regions DEV 1 to DEV 12,
respectively.
[P-BUS]: This selects P-BUS.
[ALL]: This selects all valid regions.
[MASTR]: This selects the master timeline (see “Creating and Saving a
Master Timeline” (page 145)).
Note
The regions that can be selected simultaneously are those assigned to the
region selection buttons in the numeric keypad control block. (See
“Assigning the region selection buttons in the numeric keypad control
block” (page 210).)
It is not possible to select [MASTR] and other regions simultaneously. If
selected simultaneously, the master timeline takes precedence.
The first button pressed lights green as the reference region, and any
subsequently pressed buttons light amber.
For details of the precedence order for becoming the reference region, see
“Regions and Registers” in Chapter 1 (Volume 1).
The display shows the name of the reference region, and the number of the
last register recalled for this region.
3
Enter the number of the register you want to recall, using the numeric
keypad.
To find an empty register, instead of entering a number, press the [.]
(period) button. To search for an empty register common to all currently
selectable regions, press the [.] button again.
To search for an empty register in the 100 range, press [1], [0], [0], [.]
(period) in this order. Similarly, to search for an empty register in the 200
range, press [2], [0], [0], [.] (period).
The register number appears in the display. If the number is followed by a
letter ‘e’ or ‘E’, this indicates the following.
e: The selected register is empty for the regions selected in step 2.
E: The selected register is empty for all currently selectable regions.