Filter
Top Products
211Setup Relating to Operations From the Control Panel
Chapter 16 Engineering Setup
• Turn the knob to make the setting.
4
Press [Set] to confirm the selection.
This assigns the region to the region selection button in the numeric
keypad control block.
To return the region assignments to the factory default
In the 10 Key Region Assign menu, press [Default].
This returns the assignments of the region selection buttons in the numeric
keypad control block to the factory default.
To clear a region assignment
Use the following procedure.
1
In the 10 Key Region Assign menu, press the indication for the button to
which the region is assigned.
The button you pressed turns to reverse video.
2
Press [Clear].
This clears the assignment of the selected button, which is now no longer
assigned.
Setting program button assignment
You can change the assignment of some of the buttons in a standard type
transition control block for use in VTR operations. Use the following
procedure.
1
In the Panel>Config menu, press [Program Button].
The Program Button menu appears.
2
Press [Transition Module].
The Transition Module menu appears.
3
Using any of the following methods, select the bank.
• Press directly on the list in the status area.
• Press the arrow keys to scroll the reverse video cursor.
Knob Parameter Adjustment Setting values
1 Region Region selection 1 to 35