Filter
Top Products
235Setup Relating to Switcher Processor
Chapter 16 Engineering Setup
Setup Relating to Switcher Processor
Settings for Switcher Configuration (Config Menu)
To make settings for the switcher processor configuration, use the
Switcher>Config menu.
To display the Config menu
In the Engineering Setup menu, select VF3 ‘Switcher’ and HF1 ‘Config.’
The status area shows the output signal assignment for each operating bank.
Adjusting the reference phase
To adjust the switcher internal reference phase, adjust the following parameter
in the Switcher>Config menu.
Specifying the video switching timing
In the <Switching Timing> group of the Switcher>Config menu, select one of
the following.
Any: Not specified
Field 1: Field 1 (odd fields)
Field 2: Field 2 (even fields)
Setting the operation mode
In the <M/E Config> group of the Switcher>Config menu, select the operation
mode for each M/E or P/P bank from the following.
• Standard mode
• Multi Program mode
• DSK mode (P/P only)
For details of the modes, see “Switcher Setup” in Chapter 1 (Volume 1).
Note
When Multi Program mode is selected, two or more transition type indication
may light. It is also possible that more than one “Transition Type” has been
selected in the Misc>Transition menu for each M/E.
Knob Parameter Adjustment Setting values
3 Phase Switcher internal reference phase −32.00 to +96.00