Filter
Top Products
27DME Special Effect Operations
Chapter 11 DME Operations
Note
Edges cannot be softened when the Crop effect is disabled.
Beveled Edge Settings
This effect applies a beveled frame appearance to an image.
For sample images, see “DME Special Effects” in Chapter 1 (Volume 1).
Applying a beveled edge
Use the following procedure.
1
In the DME menu, select VF1 ‘Edge’ and HF2 ‘Beveled Edge.’
The Beveled Edge menu appears.
2
Press [Beveled Edge], turning it on.
This enables the beveled edge, and you can now use the knobs to adjust the
edge width parameters.
Note
When the border is enabled, the edge soft function (see page 26) is not
available.
3
Set the parameters.
The valid ranges of the parameter values depend on the aspect ratio (4:3/
16:9) selected in the system, as follows.
• 4:3 mode
• 16:9 mode
Knob Parameter Adjustment Setting values
1 H Simultaneously adjust width of left
and right edges
0.00 to 4.00
2 V Simultaneously adjust width of top
and bottom edges
0.00 to 3.00
3 All Simultaneously adjust width of all
four edges
Value of H shown
Knob Parameter Adjustment Setting values
1 H Simultaneously adjust width of left
and right edges
0.00 to 4.00