Filter
Top Products
215Setup Relating to Operations From the Control Panel
Chapter 16 Engineering Setup
2
In the <Sub Table Select> group, select the sub table you want to set.
3
Using any of the following methods, select the cross-point button for
which you want to make an assignment.
• Press directly on the list in the status area.
• Press the arrow keys to scroll the reverse video cursor.
• Turn the knob to make the setting.
• To disable operation of a button number, press [Inhibit].
4
Turn the knob to select the main cross-point button number to be assigned.
To select a cross-point button number while checking which
sources can be selected
In place of steps 3 and 4 in the above procedure, you can use the following
procedure for the setting.
1
Press [Source Select].
The Source Select menu appears.
In the upper part of the status area, the selected Sub and Main button
numbers and the currently assigned video and key signal names appear. In
the lower part, a list of the assignable signals appears.
2
Referring to steps 3 and 4, select the signal to be assigned.
Setting the cross-point button shift operation
You can set the operation of the rightmost button in each row of cross-point
buttons excluding the reentry buttons.
In the <Xpt Shift Mode> group of the Panel>Xpt Assign>Multi Xpt Assign
menu, select one of the following for each cross-point table.
Hold: Acts as a shift button, and the shifted version of the cross-point buttons
is enabled while the button is held down.
Lock: Acts as a shift button, and pressing the button toggles between the
shifted version and the unshifted version.
Off: Acts as a cross-point button, in a 16-button system as button number 16,
in a 24-button system as button number 24, and in a 32-button system as
button number 32.
Knob Parameter Adjustment Setting values
1 Sub Button No Sub cross-point button selection 1 to 128
Knob Parameter Adjustment Setting values
3 Main Source No Main cross-point button selection 1 to 128