Filter
Top Products
Chapter 16 Engineering Setup
236
Setup Relating to Switcher Processor
To assign the output of each bank in Multi Program mode
When you selected [Multi Program] in the procedure described in “Setting the
operation mode” (page 235), use the following procedure.
1
In the Switcher>Config menu, press [M/E Output Assign].
The M/E Output Assign menu appears.
2
On the list in the status area, select the bank output to be assigned.
The selected output appears in reverse video.
3
In the <M/E Output Assign> group, select the output signal to be assigned.
To set the output configuration for each bank
When you selected [Multi Program] or [DSK] in the procedure described in
“Setting the operation mode” (page 235), use the following procedure.
1
In the Switcher>Config menu, press [PGM Config].
The PGM Config menu appears.
The status area shows the background and key configuration assigned to
the output of each bank.
2
Using either of the following methods, select the output for which you
want to make the setting.
• Press directly on the list appearing in the status area.
• Press the arrow keys to scroll the reverse video cursor.
The selected output appears in reverse video.
3
In the <Bkgd> group, select the background.
In Multi Program mode, select [Clean] or [Utility2], then skip to step 5.
In DSK mode, select one of [Bkgd1] to [Bkgd4].
4
In DSK mode, turn the knobs to select the background signal.
a) 1 to 6: M/E1 OUT1 to 6
7 to 12: M/E2 OUT1 to 6
13 to 18: M/E3 OUT1 to 6
Knob Parameter Adjustment Setting values
2 to 5 Bkgd1 to 4 Background signal selection
1 to 18
a)