Filter
Top Products
229Setup Relating to Operations From the Control Panel
Chapter 16 Engineering Setup
The status area shows a list of the items with their settings.
2
Make the following settings as required.
Effect recall mode: To select the state of the first keyframe when an effect
is recalled, select [Recall] (the first keyframe is not recalled) or
[Recall&Rewind] (the first keyframe is recalled) in the <Recall
Mode> group.
Automatically turning [EDIT ENBL] off: When an effect is recalled
with the [EDIT ENBL] button on, to automatically turn this button off,
disabling keyframe editing, turn [Edit Enable Auto Off] on.
Automatic first keyframe insertion: When an empty register is recalled,
to automatically insert a first keyframe of the state at that point, turn
[1st KF Auto Insert] on.
Automatic effect saving: To automatically save an effected when it is
recalled after being edited, turn [Effect Auto Save] on.
Keyframe duration default value: Press [Default KF Duration], then
enter the default value from the numeric keypad window.
Setting the first keyframe when a rewind is executed
For P-Bus, GPI, and DDR/VTR timeline operations, to execute the first
keyframe when a rewind is carried out, set each external device on in the
<REWIND&1st KF> group.
Note
When an effect is executed by pressing the [RUN] button with this setting on,
the first keyframe action is not executed.
GPI: setting for the GPI timeline
P-Bus: setting for the P-Bus timeline
DDR/VTR: setting for the VTR/disk recorder timeline
Setting the Source and Destination names
To set the Source and Destination names used in the control panel, use the
following procedure.
1
In the <Source/Dest Name> group of the Panel>Operation menu, select the
names to be used from the following.
SW’er Local: Source names set in the Xpt Assign menu, and fixed bus
names
S-Bus Descript: Description names set in the routing switcher
S-Bus Type + No.: Type + No. set in the routing switcher (In this case
always eight characters.)