Filter
Top Products
Chapter 11 DME Operations
24
DME Special Effect Operations
Adding a border
Use the following procedure.
1
In the DME menu, select VF1 ‘Edge’ and HF1 ‘Border/Crop.’
The Border/Crop menu appears.
2
Press [Border], turning it on.
The Border effect is enabled. You can adjust the border width parameters
with the knobs.
Note
Once the Border effect is enabled, you cannot use the Edge Soft effect (see
page 26).
3
Set the parameters.
Parameter limits vary as shown below, depending on the aspect ratio (4:3
or 16:9) selected in the system.
•4:3 mode
• 16:9 mode
Knob Parameter Adjustment Setting values
1 H Border width on left and right
sides
Left value shown
2 V Border width on top and bottom
sides
Top value shown
3 All Border width on all sides Left value shown
5 Density Border density 0.00 to 100.00
6 Top Border width on top side −6.00 to +6.00
7 Left Border width on left side
−8.00 to +8.00
8 Right Border width on right side
−8.00 to +8.00
9 Bottom Border width on bottom side
−6.00 to +6.00
10 Density Border density 0.00 to 100.00
Knob Parameter Adjustment Setting values
1 H Border width on left and right
sides
Left value shown
2 V Border width on top and bottom
sides
Top value shown
3 All Border width on all sides Left value shown