Filter
Top Products
Chapter 16 Engineering Setup
242
Setup Relating to Switcher Processor
4
Press [Set] to confirm the assignment.
Selecting the output signal to which settings apply
In the following video clip adjustment, vertical blanking interval adjustment
and through mode setting, and safe title setting, use either of the following
methods to select the output signal before making the setting.
• Press directly on the list in the status area.
• Press the arrow keys to move the reverse video cursor.
The selected output signal appears in reverse video.
Adjusting the video clip
To adjust the clip value for each of the output signals from the Output 1 to 48
ports, use the following procedure.
1
In the Switcher>Output menu, press [Video Clip].
The Video Clip menu appears.
The status area shows the output ports and assigned signals, and the white
clip, dark clip, and chrominance clip values.
2
Adjust the following parameters.
To set the values to the default values, press [Default].
Making vertical blanking interval adjustment and through mode
settings
Use the following procedure.
1
In the Switcher>Output menu, press [V Blank/Through].
The V Blank/Through menu appears.
The status area shows the output ports and the assigned signals, the vertical
blanking interval, and the through mode Enable/Disable status.
Knob Parameter Adjustment Setting values
1 White Clip Luminance signal white clip value 90.00 to 109.02
2 Dark Clip Luminance signal dark clip value −6.85 to +10.00
3 Chroma Clip Chrominance signal clip value 90.00 to 113.17