Sony CCp-8000 Water Dispenser User Manual


 
287Setup Relating to Router Interface and Tally
Chapter 16 Engineering Setup
1
In the <Device> group of the Router/Tally>Parallel Tally menu, select
DCU1 or DCU2.
2
Using any of the following methods, select the slot number and port
number.
Press directly on the list appearing in the status area.
Press the arrow keys to scroll the reverse video cursor.
Turn the knobs to make the setting.
3
Press [Set].
The Set menu appears.
4
In the <Source/Destination> group, select the tally type.
Src: Return a tally to all sources output to the destination.
Dest: Return a tally to the destination outputting the source to which a
source tally is returned.
5
Set the destination address and level.
The level setting is only required when in step 4 you selected Destination.
6
When setting the tally type, set the following parameters.
a) When you selected Group1 to 4 in the section “Setting the tally groups” (page 280), this is
1:R1, 2:G1, 3:R2, 4:G2, 5:R3, 6:G3, 7:R4, and 8:G4.
When you selected Group5 to 8, this is 1:R5, 2:G5, 3:R6, 4:G6, 5:R7, 6:G7, 7:R8, and
8:G8. (R is an abbreviation of “Red Tally,” and G of “Green Tally.”)
7
Press [Execute].
This makes the parallel tally settings, in accordance with the settings in
steps 1 to 6.
Knob Parameter Adjustment Setting values
1 Slot No Parallel tally slot number 2 to 6
2 Port No Parallel tally port number 1 to 54
Knob Parameter Adjustment Setting values
1 Address Destination address 1 to 1024
2 Level Destination level 1 to 8
Knob Parameter Adjustment Setting values
3 Type Tally type
1 to 8
a)