Filter
Top Products
Chapter 11 DME Operations
26
DME Special Effect Operations
2
Press [Crop], turning it on.
The Crop effect is enabled. You can adjust degree of cropping with the
knobs.
3
Set the parameters.
Parameter limits vary as shown below, depending on the aspect ratio (4:3
or 16:9) selected in the system.
•4:3 mode
• 16:9 mode
4
To soften the edges of the image, press [Edge Soft], turning it on, and set
the following parameter.
Knob Parameter Adjustment Setting values
1 H Crop positions on left and right
sides
Left value shown
2 V Crop positions on top and
bottom sides
Top value shown
3 All Crop positions on all sides Left value shown
6 Top Crop position on top side
−3.00 to +3.00
7 Left Crop position on left side
−4.00 to +4.00
8 Right Crop position on right side
−4.00 to +4.00
9 Bottom Crop position on bottom side
−3.00 to +3.00
Knob Parameter Adjustment Setting values
1 H Crop positions on left and right
sides
Left value shown
2 V Crop positions on top and
bottom sides
Top value shown
3 All Crop positions on all sides Left value shown
6 Top Crop position on top side
−2.25 to +2.25
7 Left Crop position on left side
−4.00 to +4.00
8 Right Crop position on right side
−4.00 to +4.00
9 Bottom Crop position on bottom side
−2.25 to +2.25
Knob Parameter Adjustment Setting values
1 Soft Softness of edges 0.00 to 100.00