Filter
Top Products
Chapter 11 DME Operations
20
Three-Dimensional Transformation Operations
Use the DME menu to make graphics display settings. You can make separate
settings for separate channels. To select a target DME channel, use the device
control block.
Displaying graphics
Use the following procedure.
1
In the menu control block, select the top menu selection button [DME].
The DME menu appears.
2
Select VF6 ‘Input/Output’ and HF4 ‘Graphic.’
The Graphic menu appears.
3
Turn the [Graphic] button on.
The system enters graphics display mode, enabling graphics to be
displayed in the monitor screen.
4
Turn on the buttons of the graphics you want to show.
To show axes: Turn [Axis] on.
To show axis names: Turn [Axis Name] on.
To show the channel ID: Turn [Ch ID] on.
To show a wire frame: Turn [Wire Frame] on.
To show the grid: Turn [Grid] on.
The selected graphics appear in the monitor screen.
5
If you want to shrink the graphics display to show the range not displayed
on a normal monitor, turn the [Scale] button on and set the following
parameters.
As the value of the setting grows, the monitor shrinks further toward the
center point.
Knob Parameter Adjustment Setting values
1 Scale Degree to which the graphics
display is shrunk
0.00 to 100.00