Sony CCp-8000 Water Dispenser User Manual


 
Chapter 16 Engineering Setup
250
Setup Relating to Switcher Processor
3
Press [Link Bus Select].
The Link Bus Select menu appears.
The status area lists the current setting status of the selected link and the
buses that can be selected.
4
In the <Bus Select> group, select [Master Bus] (link source bus).
5
Using any of the following methods, select the bus to be the link source,
and press [Bus Set].
Press directly on the list appearing in the status area.
Press the arrow keys to scroll the reverse video cursor.
Turn the knob to make the setting.
a) Only when [Master Bus] is selected, 115 (M/E-1 Trans PGM), 116 (M/
E-2 Trans PGM), 117 (M/E-3 Trans PGM), and 118 (P/P Trans PGM)
are available. When [Linked Bus] is selected, 115 to 118 are not
available.
Note
With one of 113 to 116 selected for [Master Bus], linking is carried out
as soon as you start moving the fader lever.
6
In the <Bus Select> group, select [Linked Bus] (link destination bus).
7
Referring to step 5, select the bus to be the link destination, and press [Bus
Set].
8
Turn the knob to select the link table, and press [Link Table Set].
For more information about link tables, see the following item.
The status area reflects the current setting status.
To delete a link
Select the link you want to delete, then press [Clear] in the Internal Bus Link
menu.
Making link table settings
Use the following procedure.
Knob Parameter Adjustment Setting values
2 No Bus selection
1 to 118
a)
Knob Parameter Adjustment Setting values
3 Link Table No Link table selection 1 to 8