Sony CCp-8000 Water Dispenser User Manual


 
Chapter 16 Engineering Setup
208
Setup Relating to Operations From the Control Panel
The status area shows the status of the currently selected matrix, and a list
of the source and destination start addresses that can be selected.
In this menu too, you can use the knobs to select the link for the setting.
2
Using any of the following methods, define the position of the matrix to be
linked.
Press directly on the list appearing in the status area.
Press the arrow keys to scroll the reverse video cursor.
Turn the knobs to make the setting.
3
To confirm a source address selected in step 2, press [Source Set] to
confirm a destination address press [Destination Set], and to confirm a
level press [Level Set].
This confirms the selection, which is reflected in the status area.
To set a link table
For the link selected in the External Bus Link menu, make the settings as
follows.
1
In the Panel>Config>External Bus Link>Link Matrix Adjust menu, press
[Link Table Adjust].
The Link Table Adjust menu appears.
The status area lists the status of the currently selected link, combinations
of video signals and sources, and the sources that can be selected.
2
Using any of the following methods, select the switcher cross-point button
and the matrix source to be linked to the button.
Press directly on the list appearing in the status area.
Press the arrow keys to scroll the reverse video cursor.
Turn the knobs to make the selection.
Knob Parameter Adjustment Setting values
2 Source Source start address 1 to 897
3 Destination Destination start address 1 to 897
4 Level Level 1 to 8
Knob Parameter Adjustment Setting values
1 Main No Switcher cross-point button 1 to 128
2 Source No Matrix source selection 1 to 128