Filter
Top Products
247Setup Relating to Switcher Processor
Chapter 16 Engineering Setup
The status area shows the key memory settings, mask and border processing
order, key priority, cross-point hold, pattern limit transition, and wipe edge
settings for each operating bank.
Switching video process memory on or off
In the Switcher>Key/Wipe/FM menu, press [Video Proc Memory], turning it
on. (See also “Switcher Setup” in Chapter 1 (Volume 1).)
Settings for the show key function
Use the following procedure.
1
In the Switcher>Key/Wipe/FM menu, press [Show Key].
The Show Key menu appears.
2
In the <Show Key Enable> group, press the signal for which “show key”
is enabled, turning it on.
3
To set the time for which “show key” is held, press [Hold Time].
4
Adjust the following parameter.
Settings for DSK auto drop function
Use the following procedure.
1
In the Switcher>Key/Wipe/FM menu, press [DSK Auto Drop].
The DSK Auto Drop menu appears.
2
In the <DSK Auto Drop> group, press one of [DSK1] to [DSK4] for which
you want the DSK to be deleted automatically, turning it on.
Automatically naming and saving to frame memory
In the Switcher>Key/Wipe/FM menu, press [FM Auto Store], turning it on.
Selecting the bank to which the settings apply
For the section “Selecting the key memory mode” and subsequent sections,
select the operating bank to which the settings apply using any of the following
methods, then make the settings.
Knob Parameter Adjustment Setting values
1 Hold Time Show key hold time 0 to 999 (frames)