Sony CCp-8000 Water Dispenser User Manual


 
223Setup Relating to Operations From the Control Panel
Chapter 16 Engineering Setup
Making control panel GPI input settings
Use the following procedure.
1
In the Panel>Device Interface menu, press [GPI Input].
The GPI Input menu appears.
2
Using any of the following methods, select the settings.
Press directly on the list appearing in the status area.
Press the arrow keys to scroll the reverse video cursor.
Turn the knob to make the setting.
3
In the <Trigger Type> group, select the trigger type.
: Apply the trigger on a rising edge of an input pulse.
: Apply the trigger on a falling edge of an input pulse.
: Apply the trigger on a change in the polarity of the input signal.
(Level): Carry out the specified operation when the input is low or
high.
No Operation: Apply no trigger on an input pulse.
4
In the <Target> group, select the action block.
M/E-1, M/E-2, M/E-3, P/P: Set the action for one of the operating banks.
Common/Setup: Set an action for something other than the above, or a
setup action.
5
Using any of the following methods, select the action to be set.
Press directly on the list appearing in the status area.
Press the arrow keys to scroll the reverse video cursor.
Turn the knobs to make the setting.
a) Action list when the trigger type is other than “Level”
Knob Parameter Adjustment Setting values
1 Port Port selection 1 to 8
Knob Parameter Adjustment Setting values
2 Action Action selection
1 to ...
a)
5 Reg No Register number
1 to 4
b)
1 to 99
c)
1 to 399
d)