Sony CCp-8000 Water Dispenser User Manual


 
Chapter 14 Snapshots
174
Snapshot Operations in the Menus
Turn the knobs to make the setting.
To select all registers, press [All].
5
In the <Recall Mode> group, select one of the following modes for save
and recall operations.
XPT: Only the key material selection data is saved or recalled.
Modifier: Only the key modifier settings are saved or recalled.
Transition: Only the independent key transition settings are saved or
recalled.
Creating and Saving a Master Snapshot
To save a master snapshot in the Snapshot menu, after recalling the
Snapshot>Master Snapshot>Store menu, refer to the operations in “Creating
and Saving a Master Timeline With the Menu” (page 147).
Recalling the Store menu
Carry out the following procedure.
1
Do either of the following.
In the menu control block, press the top menu selection button
[SNAPSHOT].
In the numeric keypad control block, press the [SNAPSHOT] button
twice in rapid succession.
The Snapshot menu appears.
2
Press VF1 ‘Master Timeline’ and HF1 ‘Store.’
The Master Snapshot>Store menu appears.
The status area shows the master snapshot register names, register lock
status, register number for each region, and so on.
3
If required, press the following buttons in the status area to change the
region display.
M/E, P/P: indicate assignment of M/E-1 (“M/E1”), M/E-2 (“M/E2”), M/
E-3 (“M/E3”), and P/P (“P/P”).
Knob Parameter Adjustment Setting values
1 Register Register number 1 to 4
3 Num Select number of registers 1 to 4