Filter
Top Products
Chapter 16 Engineering Setup
256
Setup Relating to Switcher Processor
Carrying out level settings
To set the low level and high level, first set the trigger type to “Level,” then use
the following procedure.
1
In the Switcher>Device Interface menu, select the action to be set, and
press [H/L Set].
The H/L Set menu appears.
2
Using any of the following methods, select the settings.
• Press directly on the list appearing in the status area.
• Press the arrow keys to scroll the reverse video cursor.
• Turn the knob to make the setting.
3
To apply the selection made in step 2 when the input is high, press [H Set].
To apply the selection made in step 2 when the input is low, press [L Set].
This confirms the setting, which appears in the status area.
Note
When the action is “Format,” these settings conflict with the current
settings, but after making the settings, agreement is restored after a pulse
change or power off/on.
Making switcher processor GPI output settings
Use the following procedure.
1
In the Switcher>Device Interface menu, press [GPI Output].
The GPI Output menu appears.
2
Using any of the following methods, select the settings.
• Press directly on the list appearing in the status area.
• Press the arrow keys to scroll the reverse video cursor.
• Turn the knob to make the setting.
Knob Parameter Adjustment Setting values
1 No Signal format/screen aspect ratio
selection
1 to ...
Knob Parameter Adjustment Setting values
1 Port Port selection 1 to 8