Filter
Top Products
Chapter 13 Keyframe Effects
146
Creating and Saving a Master Timeline
7
Press the [ENTER] button.
The regions selected in step 3 and the register numbers recalled in those
regions are saved in the master timeline register, and the [STORE] button
goes off. At the same time, the [RCALL] button lights.
Notes
• It is not possible to undo a master timeline save.
• Saving the master timeline does not carry out a save of effects. Save the
effects for each region first, then carry out the master timeline save.
Amending a master timeline
You can amend information already saved in a master timeline.
As an example, to change the M/E-1 register from Effect 5 to Effect 10, use the
following procedure.
Information in master timeline register 1 before change
Information in master timeline register 1 after change
1
Recall the master timeline register you want to amend. (See “Recalling a
Register” (page 115).)
This simultaneously recalls M/E-1 register 5 and M/E-2 register 5, and the
[M/E-1] and [M/E-2] region selection buttons light.
2
Press the region selection button [MASTR], turning it off.
3
Turn on only the button for the region you want to change (here, [M/E-1]),
and recall the desired register (here, Effect 10).
This recalls M/E-1 register 10, while on M/E-2 register 5 remains selected.
Region Register
M/E-1 Effect 5
M/E-2 Effect 5
Region Register
M/E-1 Effect 10
M/E-2 Effect 5