Sony CCp-8000 Water Dispenser User Manual


 
317Macro Operations in the Flexi Pad Control Block
Chapter 18 Macros
For details of the correspondence between banks and registers, see “Banks
and Registers” (page 165).
Recalling a Macro Register and Executing a Macro
To carry out a macro operation, recall a macro register.
To recall a macro register, use the following procedure.
1
In the Flexi Pad control block, press the [MCRO] button, turning it on.
This assigns the Flexi Pad control block to macro operations.
The numeric display shows the previously selected bank number and the
last recalled register number.
2
Use any of the following operations to select the bank for recall.
To select bank 0: Press the [BANK0] button.
To select bank 1: Press the [BANK1] button.
To select any of banks 0 to 9: Press the [BANK SEL] button, changing
the memory recall section display as shown below; select a number
from 0 to 9.
The selected bank number appears in the numeric display.
Each button in the memory recall section shows the corresponding register
name and register status for the selected bank.
Note that in the Setup menu, you can select whether to display register
names or register numbers.
Lit orange: Register holding macro data
Lit yellow: Last recalled register
Off: Empty register
7 8 9
4 5 6
1 2 3
0
Example: