Filter
Top Products
Chapter 16 Engineering Setup
210
Setup Relating to Operations From the Control Panel
The Key Trans Link menu appears.
The status area shows the keyers for each M/E bank and the linked keyers.
2
Using any of the following methods, select the keyer to be the master.
• Press directly on the list appearing in the status area.
• Press the arrow keys to scroll the reverse video cursor.
• Turn the knob to make the setting.
The selected keyer appears in reverse video.
3
In the <Key Select> group, select the keyer to be linked to the transition of
the master.
Note
Linking does not apply to a transition carried out with the downstream key
control block.
Selecting the module to be the reference for device control block
In the <Reference Module> group of the Panel>Config menu, select the
module to be the reference.
• Trackball
•Joy Stick
Assigning the region selection buttons in the numeric keypad
control block
Use the following procedure.
1
In the Panel>Config menu, press [10 Key Region Assign].
The 10 Key Region Assign menu appears. On the left of the status area the
region selection buttons are shown, and on the right a list of the assignable
regions.
2
Press the indication for the button you want to assign.
The button you pressed turns to reverse video.
3
Using any of the following methods, select the region to be assigned.
• Press directly on the list.
• Press the arrow keys to scroll the reverse video cursor.
Knob Parameter Adjustment Setting values
1
Master Key Select keyer to be master
1 to 16