Filter
Top Products
Chapter 13 Keyframe Effects
130
Creating and Editing Keyframes
To change the loop count only, press the [ENTER] button, then skip to step
6.
When you press the [CLEAR] button, this appears as follows.
3
Enter the keyframe number for the new start point, and press the [ENTER]
button.
4
Enter the keyframe number for the new end point, and press the [ENTER]
button.
The display shows the currently set loop count.
5
To change the setting, press the [CLEAR] button.
This clears the set loop count.
6
Enter the new loop count, and press the [ENTER] button.
Executing a keyframe loop
In the keyframe control block, press the [RUN] button.
The set loop range is executed repeatedly for the set loop count number of
times.
The screen shows the total loop count and the number of loops remaining. (If
the loop count is infinite (inf), the remaining number is not shown.)
If the [REV] button is lit, the loop is played in the reverse order.
Canceling keyframe loop execution
Press the [REWIND] button in the keyframe control block.
Changes to the loop range caused by keyframe insertion/
deletion
When a keyframe is inserted or deleted within the loop range, the loop range
also changes. The following are examples.
Example 1: If keyframe 3 is deleted, the loop end point moves forward as
follows.
FM TO
COUNT