Sony CCp-8000 Water Dispenser User Manual


 
183Shotbox Register Creation
Chapter 15 Utility/Shotbox
To change the contents of a shotbox register
After recalling the shotbox register you want to change, referring to the
previous item “Creating a shotbox register,” change the contents of the
shotbox register, and save.
To check the region saved in a shotbox register
During operations to change the contents of a shotbox register, to check which
region is saved in the register, use the following procedure.
1
With the [SHOTBOX] button lit, press the [STORE] button, turning it on.
2
Press the required button, as follows, turning it on.
To check the snapshot region: [SNAPSHOT] button
To check the effect region: [EFF] button
3
Hold down the [STORE] button.
While this button is held down, the button for the saved region lights.
Releasing the button returns you to the state before holding down the
[STORE] button.
Note
While the [STORE] button is lit, the mode selection buttons ([TRANS RATE]
button and so on) in the numeric keypad control block do not operate. To
change the mode, press the [RCALL] button or [SHOTBOX] button so that the
[STORE] button goes off.
Creating a Shotbox Register Using the Menus
Accessing the Shotbox menu
Carry out creation and editing of shotbox registers in the Shotbox menu.
To access the Shotbox menu, use any of the following methods.
In the menu control block, press the top menu selection button [SHOTBOX].
In the numeric keypad control block, press the [SHOTBOX] button twice in
rapid succession.
Creating a shotbox register
Use the following procedure.
1
In the Shotbox menu, press VF1 ‘Register’ and HF1 ‘Store/Recall.’
The Store/Recall menu appears.