Filter
Top Products
185Shotbox Register Creation
Chapter 15 Utility/Shotbox
5
Using any of the following methods, select the desired region. You may
select more than one region.
• Press directly on the region display in the status area, turning it to reverse
video.
• Press [All] to select all regions.
• To cancel a selection, press once more to return to the normal display.
6
In the <Assign> group, select the snapshot or effect to be allocated to the
region.
[Snapshot]: Allocate a snapshot register.
[Effect]: Allocate a keyframe effect.
7
Depending on the selection in step 6, set the parameters as follows.
• When a snapshot is selected
• When an effect is selected
a) For the DME region, you can also set register numbers 101 to 199 and 201 to 299.
8
To run the allocated effect as soon as it is recalled, press [Auto Run],
turning it on.
9
Repeat steps 5 to 8 as required.
10
In the <Store> group, press [Store] to save the setting.
To return to the state before saving the setting
In the <Store> group, press [Undo].
To run the settings to check them
Press [Recall] to run the shotbox.
Knob Parameter Adjustment Setting values
2 Snapshot Snapshot register number 1 to 99
Knob Parameter Adjustment Setting values
2 Effect Keyframe effect number
1 to 99
a)