Sony CCp-8000 Water Dispenser User Manual


 
289Setup Relating to Router Interface and Tally
Chapter 16 Engineering Setup
1
In the Serial Tally menu, press [Source Assign].
The Source Assign menu appears.
In the status area, the tally types and source address set for the serial tally
port appear.
2
In the <Serial Tally Port> group, select the port to which the setting
applies.
3
Using any of the following methods, select the port bit number.
Press directly on the list on the left of the status area.
Press the arrow keys to scroll the reverse video cursor.
Turn the knob to make the selection.
4
Turn the knob to select the source address.
5
Press [Source Address Set].
This confirms the setting.
Clearing a source address setting
To clear a source address setting for a particular bit
In the Source Assign menu, select the serial tally port and bit number (see steps
2 and 3 in the previous item), then press [Clear].
This clears the source address setting for the selected bit.
To clear all source address settings
In the Source Assign menu, select the serial tally port, then press [All Clear].
A confirmation message appears.
If you select “Yes,” this clears all source address settings for the selected
serial tally port.
If you select “No,” the clear operation is canceled.
Knob Parameter Adjustment Setting values
1 Bit No Bit selection 1 to 128
Knob Parameter Adjustment Setting values
2 Source Addr Source address selection 1 to 1024