Sony CCp-8000 Water Dispenser User Manual


 
171Snapshot Operations in the Menus
Chapter 14 Snapshots
5
In the <Attribute> group, press the buttons for the attributes you want to
apply, turning them on.
Carry out the following procedures for each of the attributes.
To apply the cross-point hold attributes
1
Press [XPT Hold], turning it on.
The Snapshot>Attribute>Xpt Hold menu appears. The status area shows a
list of the currently selected regions and bus names.
2
Using either of the following methods, select the register.
Press directly on the list in the status area.
Press the arrow keys to scroll the reverse video cursor.
Turn the knobs to make the setting.
To select all registers, press [All].
3
Press [On].
This enables cross-point hold on the selected bus or buses.
To switch cross-point hold off, press [Off].
To apply the effect dissolve attribute
1
Press [Effect Dissolve], turning it on.
2
Turn the knob to set the effect dissolve duration.
To apply the auto transition attribute
Press [Auto Transition], turning it on.
To apply the GPI output attribute
1
Press [GPI Output], turning it on.
Knob Parameter Adjustment Setting values
2 Bus Bus name selection
3 Num Select number of buses
Knob Parameter Adjustment Setting values
2 Duration Dissolve duration 0 to 999 (frames)