Filter
Top Products
Chapter 16 Engineering Setup
282
Setup Relating to Router Interface and Tally
3
Set the source.
Source From: Specify the source start address for the wiring
configuration.
Source Level: Specify the source level for the wiring configuration.
4
Press [Execute].
This makes the wiring setting according to the specifications in steps 2 and
3.
Changing the wiring settings
Use the following procedure.
1
In the Router/Tally>Wiring menu, press [Modify].
The Modify menu appears.
2
Referring to steps 2 and 3 in the preceding section “Making new wiring
settings,” change the parameters as required. In this case, however, it is not
possible to specify multiple destinations in a single operation, and a single
“Destination Address” must be specified.
3
Press [Execute].
This updates the wiring settings.
Deleting wiring settings
Use the following procedure.
1
In the Router/Tally>Wiring menu, using either of the following methods,
select the wiring whose settings you want to delete.
• Press directly on the list appearing in the status area.
• Press the arrow keys to scroll the reverse video cursor.
2
Press [Delete].
This deletes the selected wiring entry.
Knob Parameter Adjustment Setting values
4 Source (From) Source start address 1 to 1024
5 Source (Level) Source level 1 to 8