Filter
Top Products
8-7
Cisco WAN Manager User’s Guide
Version 10.5, Part Number 78-12945-01 Rev. D0, August 2003
Chapter 8 Statistics Collection Manager
SCM Statistics Enable
Figure 8-5 SCM Stand Alone initialization
Figure 8-6 shows an xterm window displayed with the SCM main menu options:
Figure 8-6 SCM start core, stop core, and exit options
SCM Statistics Enable
Figure 8-7 shows the Statistics Enable dialog box which appears after you start the SCM core. This
window allows you to set the collection period in minutes, the time out period in minutes, the bucket
interval in minutes, the number of retries, and the peak statistics enable. The last drop-down in this
dialog box asks whether you would like to use your selected settings as a default template. The switch
implements these selected values and sends confirmation back to the SCM Controller Server.
Note Statistics Enable is only accepted from the CWM machine which is registered as Statistics
Master on the nodes. (It can be set via telnet to BPX, IGX and IPX nodes by using the
cnfstatmast command; the cnfstatsmgr command must be used for MGX-8220 and
MGX-8250/8230/8850-R1.